11 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
The product does not meet the requirements of the mandatory standard 'Consumer Protection Notice No. 12 of 2008, Consumer Product Safety Standard for Vehicle Support Stands'. The product was sold without the instruction manual and an incomplete label. The jack stand's label is missing some of the required information.
Internal defects have been identified in the seatbelt anchorage bolts (specification 7/16UNF x38mm Grade 5 anchorage bolt) that may cause the bolt to crack in certain conditions. The Seatbelt Anchorage Bolts are included in certain APV Safety Products Aftermarket Seatbelt Kits sold from 17 July 2018 to 19 January 2019.
The stroller is not compliant with the mandatory standard 'Trade Practices Act 1974 - Consumer Protection Notice No. 8 of 2007 - Consumer Product Safety Standard: Prams and Strollers'. The stroller does not have red brakes or a tether strap and does not display safety warnings or a warning on the harness.
The recall is due to microbial ( E.coli ) contamination.
The recall is due to testing showing the possible presence of E.coli .
Swing seat may tilt forward and/or frame may tip during use due to a design defect.
The buttons at the waist of the overall may detach from the garment.
The ceiling fan is designed to have a non-removable light cover. Some ceiling fans supplied to the market have a removable light cover.
The battery compartment of the wristband is not adequately secured and the button batteries in the product are easily accessible.
There is a possibility that the engine oil cooler hoses may separate from the banjo clamp joints due to insufficient clamping strength and as a result, engine oil could leak. There is also a possibility that the fuel tank cap gasket could become pinched and torn when the tank cap is installed on the filler neck. As a result, fuel and fuel vapour may leak.
Where the installation has not been carried out in accordance with the product manual, using dedicated wiring from a single battery supply, there is potential at any time for no trailer brake output indicated by a flashing yellow/red warning lamp.