Mojo Motorcycles Off-Road LANDBOSS LH1100-D vehicle
The handbrake cable has been incorrectly routed which may result in handbrake malfunction, allowing the vehicle to roll away when parked.
25 archived Australian notices, each linked to its official Product Safety Australia source. The page updates automatically when new notices arrive.
The handbrake cable has been incorrectly routed which may result in handbrake malfunction, allowing the vehicle to roll away when parked.
The ECU’s software calibration may disable warnings that the parking brake is engaged, allowing operation of the vehicle while the parking brake is on.
These products do not comply with the mandatory standard for quad bikes . The operator roll-over protection structure (ROPS) can crack and fail.
The lower seat belt anchor fasteners have not been properly torqued when the vehicle was built.
Polaris has determined that on some Model Year 2023-2024 RANGER XP Kinetic vehicles, a crack may develop on part of the charging system. The crack may allow water to contact live parts of the high voltage charging system and cause a short circuit while the vehicle is being charged.
The cabin doors may unlatch and open without warning due to a design defect.
The fasteners on the vehicle’s rollover protective structure pillar joints may be either missing or improperly tightened.
The ball joint may separate from the front suspension arm as its bolts and nuts may not be securely tightened resulting in a loss of vehicle control.
The exterior door handle actuators on some Model Year 2024-2025 Ranger XD 1500 and Crew XD 1500 vehicles may stick and cause the door to unexpectedly open while the vehicle is moving.
The throttle pedal may get stuck while in use and not return to idle.
The heater may overheat or short circuit due to a manufacturing fault.
The high voltage cables on the motor controller unit can become loose on affected vehicles. A loose cable may result in an electrical arc or overheat and cause a fire or unintended acceleration.
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a collision triggering the airbag, the metal inflator housing may explode/rupture under too much internal pressure.
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a collision triggering the airbag, the metal inflator housing may explode/rupture under too much internal pressure.
The plastic sheathing on the throttle cable may melt due to improper routing, causing the throttle to stick.
Some vehicles may be manufactured with incorrect electrical wiring to the accelerator pedal position sensor. This results in an incorrect sensor voltage to the vehicle control module which may cause unintended vehicle acceleration.
The lower main frame tube may be defective and could crack. It the lower main frame tube cracks it can result in failure of the secondary upper cab frame.
The powertrain mounting hardware may have been only hand tightened, and not torqued to the proper specification. If the hardware falls out it may lead to the engine rocking during acceleration, and pinching of the throttle cable.
The steering shaft has the potential to separate from the steering rack assembly which may result in a loss of vehicle steering control.
Repetitive bending stress during operation of the vehicles may cause the thin plate seat belt stay to fracture and it may not satisfy the strength required for the seat belt to hold secure the vehicle operator or passenger.
The dust boot on the throttle cable can come loose, allowing it to get pushed into the throttle linkage.
On certain vehicles, a foreign object such as a stick could be deflected by the front tyres into the left or right floor board.
Under certain conditions the top layer of the drive belt could peel off, leading to the belt breaking, and the vehicle losing drive.
The spring locking pin used to retain the foldable Rollover Protective Structure (ROPS) pin may not meet specifications. If the spring locking pin breaks, the ROPS pin may not be retained and fall out.
The exhaust heat shield can melt during operation.