509 and 509 for Polaris branded helmets with Fidlock® fasteners
The chin strap on affected helmets may not be routed correctly causing the retention buckle to separate and the helmet to come off.
AUSTRALIAN RECALL CATEGORY
Other sports equipment recalls.
15 archived Australian notices, each linked to its official Product Safety Australia source. The page updates automatically when new notices arrive.
Showing notices 1–15 of 15.
Nutcase Street Mozaic MIPS helmet for cycling, scooter or skateboard
This product doesn’t comply with the mandatory standard for bicycle helmets . The buckle is not permanently attached to the strap and could be removed, making the helmet unsafe.
3F Single Point Manual Inflator (Model No: V96000) in Life Jacket Solutions and Marlin life jackets
The indicator status on the inflator may show the life jacket is ready for use even when the attached gas cylinder is empty, removed or not connected properly. The life jacket cannot inflate when this happens.
Muzzle Brake 308WIN, 5/8 inch UNEF and Muzzle Brake 6.5CM, 5/8 inch UNEF for LA102 CrossOver and LA105 Woomera Rifles
A design or manufacturing fault can lead to muzzle brake baffle contact where the projectile contacts the inside of the muzzle brake before exiting the barrel and can result in: Bullet fragments exiting from the side and/or rear of the muzzle brake at speed, and/or The bullet deviating unexpectedly from the point of aim.
Morfboard Skate & Scoot Combo Set
The “Y” handle bar welding may break under excessive force while in use.
Tikka .308 Calibre Ammunition for a Centrefire Rifle
Corrosion may occur on the inside of new or reloaded ammunition cartridges, which weakens their strength.
LA102 CrossOver Rifle .223 and .243 Calibre
Over time small cracks may develop in the barrel of the .223 and .243 calibre LA102 CrossOver rifle.
Savage B.Mag 17WSM Rifle
The bolt on some B.Mag rifles may inadvertently catch the safety button and slide it into the "fire" position.
Picasso 'Magnum' Carbon Rail Speargun
The potential exists for the product to discharge unintentionally.
Assorted Skate & Roller Derby Helmets
Independent testing has identified that the above skate helmets fail to meet the requirements of the mandatory safety standard.
Remington USA - Model 700™ and Model Seven™ Rifles
Remington has determined that some Model 700 and Model Seven rifles with XMP triggers could under certain circumstances, unintentionally discharge. A Remington investigation has determined that some XMP triggers might have excess bonding agent used in the assembly process. Remington is undertaking a recall in the interest of consumer safety.
Easton Axis Arrows and Arrow Shafts
Some arrow shafts in the affected batches did not comply with Easton's quality assurance standards.
Thompson Center Venture Rifles
During an internal technical review, Smith & Wesson identified a condition that may exist with the sear supplied with some rifles that would allow the rifle to fire without the trigger being pulled. In the interest of consumer safety, we are initiating this recall to allow for the prompt inspection and, if necessary, the repair of each rifle.
“Weatherby® Vanguard® Stainless Synthetic” and “Series 2 Stainless Synthetic” Rifles
The barrel nut may not have been tightened sufficiently to meet the torque specifications.
Model 1500 Stainless Steel Rifles
The barrel nut may not have been tightened sufficiently to meet the torque specifications.