MIC Gastrostomy Feeding Tubes - expanded recall
The Instructions For Use leaflet was not supplied with the product. The Instructions For Use provide important safety information for the user.
19 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
The Instructions For Use leaflet was not supplied with the product. The Instructions For Use provide important safety information for the user.
The rattles do not comply with the size and shape requirements of the mandatory standard ‘Consumer Protection Notice No 14 of 2003- Consumer Product Safety Standard: Toys for children up to and including 36 months of age’.
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a collision triggering the airbag, the metal inflator housing may explode/rupture under too much internal pressure.
Two software issues have been identified that relate to a pressure increase in the ventilators. 1. Infant/Pediatric External Flow Sensor (EFS) Calibration Pressure increase. An increase in the expiratory pressure (EPAP/PEEP) can occur when the paediatric/infant External Flow Sensor is used with an Active Flow or Dual Limb circuit and a manual circuit calibration is performed. 2. Pressure Drift (Continuous Usage). When a Trilogy Evo or Trilogy Evo O2 model is used continuously without any interruption to therapy, the baseline pressure may increase or decrease.
When lit, the candle may overheat and break or crack the glass jar.
Certain M5072A Infant/Child SMART Pads Cartridges (LOT Number Y111220-01) contain an incorrect image underneath the PULL handle on the protective cover that shows the pad placement for an adult’s chest (Figure 2). The image on the protective cover should show a drawing of pad placement for a child’s chest and back (Figure 1). The image is correct on the outer pouch that contains the infant/child pads cartridge (Figure 3).
The products may not comply with 'Australian Standard AS1926.1 2012 Safety Barriers for Swimming Pools' section 2.4.1.2. The Gate Hinge-Closer Kits may not self close properly.
The recall is due to a packaging fault resulting in the potential for glass breakage.
The earth connection is missing from the internal metal casing. In the event of an internal component failure, the casing and mounting bracket will become live and the user can touch live parts
The earth connection is missing from the internal metal casing. In the event of an internal component failure, the casing and mounting bracket will become live and the user can touch live parts.
The earth connection may be missing from the front panel and the main power supply cable loom may be missing its harness. The user can touch live parts if the internal wiring becomes loose and makes contact with the unearthed metal enclosure.
The earth connection may be missing from the LED mounting plate and the internal wiring may be missing its harness. The user can touch live parts if the internal wiring becomes loose and makes contact with the unearthed metal enclosure.
The earth connection may be missing from the LED mounting plate and the internal wiring may be missing its harness. The user can touch live parts if the internal wiring becomes loose and makes contact with the unearthed metal enclosure.
The earth connection may be missing from the LED mounting plate and the internal wiring may be missing its harness. The user can touch live parts if the internal wiring becomes loose and makes contact with the unearthed metal enclosure.
The casing is not secured properly and the user can easily open it and access live parts.
The casing is not secured properly and the user can easily open it and access live parts.
The casing is not secured properly and the user can easily open it and access live parts.
The earth connection may be missing from the LED mounting plate and the internal wiring may be missing its harness. The user can touch live parts if the internal wiring becomes loose and makes contact with the unearthed metal enclosure.
The affected product batch 18039 exceeds the specification for total yeast and mould counts (TYMC).