Yamaha WaveRunner MY2021 - extended recall
A poorly-installed sensor in the shut-off switch assembly may allow water to seep inside the sensor (switch housing) and become corroded, causing an intermittent connection.
AUSTRALIAN RECALL ROUND-UP
17–23 May 2021.
5 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
Nimbus 4 and Nimbus Professional Mattresses
Nimbus 4 and Nimbus Professional mattresses may over-inflate, due to an inner mattress component failure. This cannot be detected until the product is disassembled.
Deimos Ultra BT A400 Australia, A600 Australia and A600 V Australia & Deimos BT A400 Australia and A600 Australia Sliding Gate Openers
The earth and live wires may not be connected correctly, and the cable gland may not hold the cables tightly enough.
Baby Multi-functional Adjustable Cot Convertible Table Mattress Mosquito Net
The product does not comply with the mandatory standard 'Trade Practices Act 1974. Consumer Protection Notice No. 6 of 2005 Consumer Product Safety Standard: Children's Household Cots'. The cot fails various design, construction, performance and labelling requirements: 1. The distance between the top of the mattress base and the top edge of the lowest cot side does not comply. 2. A foothold is created when the mosquito net is installed. 3. The cot has an accessible sharp point. 4. The access fastening device does not automatically engage when the dropside is raised and may be able to be opened by a child from within the cot. 5. The warning labels and safety markings are missing.
KTM Model SX-E 5 Motorcycles MY2021
The battery vent valve may be missing on some motorcycles, allowing water intrusion.