10 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
A Locating Collar was not installed in the Sub-Transmission of some units, which may allow the Parking Pawl to move out of alignment and not engage when the gearshift position is in Park.
The product does not comply with the requirements of the the mandatory standard 'Consumer Protection Notice No.16 of 2010 - Consumer Product Safety Standard: Children’s Projectile Toys'. The product's packaging is not labelled with the appropriate safety warning.
The product does not meet the required electrical safety standard. The affected products have a capacitor and no resistor.
This product contains small, high-powered magnets. The product exceeds the maximum allowable magnetic flux index set by the permanent ban on certain small, high powered magnets, prescribed in Consumer Protection Notice No 5 of 2012 'Imposition of permanent ban on small, high powered magnets'.
This product contains small, high-powered magnets. The product exceeds the maximum allowable magnetic flux index set by the permanent ban on certain small, high powered magnets, prescribed in Consumer Protection Notice No 5 of 2012 'Imposition of permanent ban on small, high powered magnets'.
This product contains small, high-powered magnets. The product exceeds the maximum allowable magnetic flux index set by the permanent ban on certain small, high powered magnets, prescribed in Consumer Protection Notice No 5 of 2012 'Imposition of permanent ban on small, high powered magnets'.
This product contains small, high-powered magnets. The product exceeds the maximum allowable magnetic flux index set by the permanent ban on certain small, high powered magnets, prescribed in Consumer Protection Notice No 5 of 2012 'Imposition of permanent ban on small, high powered magnets'.
The recall is due to the presence of an undeclared allergen (peanuts).
The fuel pump on affected vehicles may stop operating. If the fuel pump stops working, warning lights and messages may display on the instrument panel, and the engine may not run smoothly. This can result in the vehicle stalling and the vehicle may not be able to be restarted.
If the engine stalls, the current Engine Control Unit (ECU) calibration used may prevent the throttle plates from returning to the idle position.