15 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
A gap may develop at the folding joint. If the Nyloc anti-vibration nut is over-tightened, it will damage the T bolt within the folding joint leading to a greater gap, presenting an increased risk of finger entrapment.
The recall is due to possible microbial (Hepatitis A virus) contamination.
The product may not effectively control microbial contamination. The contamination, if present, will not be readily visible to the naked eye.
The product contains the aromatic amine o-anisidine at a concentration that may pose a risk to human health.
The products do not comply with the fire hazard labelling requirements of the mandatory standard 'Consumer Goods (Children's Nightwear and Limited Daywear and Paper Patterns for Children's Nightwear) Safety Standard 2017'. The garments do not carry the fire hazard information label.
The soothers do not comply with the Australian mandatory standard 'Consumer Goods (Babies Dummies and Dummy Chains) Safety Standard 2017'. The dummy packaging does not include required warnings, instructions for use, care instructions or contact details for the manufacturer or distributor.
The battery compartment is not adequately secured and the button batteries in the product are easily accessible.
Possibility of a crack in the fuel supply module in some engines, may result in a fuel leak.
The mug may crack or break when filled with hot water.
Potential issue with Android App versions of Dario Blood Glucose Tracker (4.3.0-4.3.2), regarding duplicate logging of a blood glucose level reading. The issue may cause blood glucose level readings that are transferred from the measurement screen to the 'Logbook' being replaced by an older blood glucose measurement and being displayed as a duplicate reading.
During testing there was greater than expected variation in CO 2 emissions between vehicles.
The clear silicone spout on the water bottle can detach.
The security arm on the Bike Carrier Adaptor could open, causing the bike to fall off the bike carrier rack.
On the Convex Two-Piece Skin Barriers, the starter hole (stoma hole) is off-centre.
The product is not equipped with reflectors that replace the rear reflector on the motorcycle, which is removed when installing this kit.