UD Trucks MKB35A & MKB37A MY2010
Due to a manufacturing defect, the rear axle hub inner bearing may be exfoliated and prolonged use may cause further damage to other parts.
AUSTRALIAN RECALL ROUND-UP
12–18 August 2019.
7 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
Trek Kickster Balance Bicycles MY2013-2019
The clamp that holds the steer tube in place may break when over-tightened, due to uncontrolled die temperature of the aluminium during the manufacturing process.
Children's 2 Piece Cotton Sleepwear
The product does not comply with the fire hazard labelling requirements of the mandatory standard 'Consumer Goods (Children's Nightwear and Limited Daywear and Paper Patterns for Children's Nightwear) Safety Standard 2017'. The garment does not carry the fire hazard information label.
Bunk Bed Solid Pine Timber Frame Wooden Kids Children Bed Frame - Single
The product does not comply with the mandatory standard 'Trade Practices Act 1974 Consumer Protection Notice No. 1 of 2003 Consumer Product Safety Standard: Bunk Beds'. The bunk beds do not meet the standard requirements for allowable protrusions, gaps between bars and the required labelling advising the Australian distributor's name and address.
Magic Mobility Wheelchair Mobility Handles
The wheelchair can drive at low speed/creeping in a circular motion without human steering.
MovitracB Frequency Inverter with Firmware 17 Installed in Devices such as In-Home Passenger Lifts
In-home passenger lifts using frequency inverters that have Firmware 17 installed may exhibit unexpected behaviour during operation.
Hino 500 Series MY2016
Due to an improper setup of programming equipment for the Gear Shift Unit (GSU) stroke sensor, this may prevent the automated manual transmission from changing gears.