Wooden Playpen
Due to a manufacturing fault in one batch, the spring ball inside the playpen that locks the moulded plastic corners into place may become loose.
7 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
Due to a manufacturing fault in one batch, the spring ball inside the playpen that locks the moulded plastic corners into place may become loose.
The recall is due to the presence of an undeclared allergen (milk). This is due to incorrect packaging (Turkey Thigh Roast was packaged incorrectly in Turkey Breast Roast packaging).
The recall is due to potential microbial (Salmonella enteritidis) contamination.
Due to the tight fit of the plastic cap, small, threadlike (up to approximately 1cm long x less than 1mm wide), soft slivers of white plastic could peel off the jar cap upon opening, potentially contaminating the product.
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a collision triggering the airbag, the metal inflator housing may explode/rupture under too much internal pressure.
If safety locking fittings are not used according to the assembly instructions, the foldable part of product may come loose or may break at or near the change table hinge.
Product is potentially dangerous if used without restraining the infant with the safety harness. Infants may roll from their backs to their stomach or side while unrestrained. Over 30 infant fatalities have occurred overseas, since 2009, in Rock ‘n Play Sleepers, after the infants rolled over while unrestrained, or under other circumstances. Around 4,000 units were supplied in Australia between 1 Jan 2010 and 31 Dec 2013.