Hoover Dual Power Plus Carpet Washer
In some instances, the rubber seal on the motor does not effectively seal the motor housing. This could allow water to flow into the motor housing area.
14 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
In some instances, the rubber seal on the motor does not effectively seal the motor housing. This could allow water to flow into the motor housing area.
The battery compartment may not be adequately secured allowing possible access to the button battery if the product is dropped on a hard surface.
The product does not comply with marking requirements of the mandatory standard 'Consumer Goods (Swimming and Flotation Aids) Safety Standard 2017' as a safety warning does not appear on the product.
The recall is due to a packaging fault resulting in the potential for the top to pop open.
Takata airbag inflator: As it gets older, a combination of heat and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a collision triggering the airbag, the metal inflator housing may explode/rupture under too much internal pressure.
Takata airbag inflator: As it gets older, a combination of heat and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a collision triggering the airbag, the metal inflator housing may explode/rupture under too much internal pressure.
Due to insufficient hose material curing at manufacturing, cracking may develop in the radiator coolant hose.
Due to insufficient hose material curing at manufacturing, cracking may develop in the radiator coolant hose.
Due to a defective shift mechanism torsion spring, riders may not be able to select the desired gear.
The recall is due to biotoxin (hydrocyanic acid) contamination.
The bow section of the fibreglass hull structure may show signs of gelcoat crazing below the cabin area of the vessel. This may weaken over time to a point where the fibreglass structure could crack.
The angle of the taper surface when fitted to the generator rotor may be out of specification with the crankshaft. This may place continued load on the key groove on the taper surface of the crank shaft, which could cause damage to the engine.
The recall is due to the potential presence of plastic.
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a collision triggering the airbag, the metal inflator housing may explode/rupture under too much internal pressure.