Recall archive/Weekly round-ups/6–12 February 2017
AUSTRALIAN RECALL ROUND-UP

6–12 February 2017.

11 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.

Bicycles and scooters (push)

Merida Speeder 20-D

The fork dropout safety tabs may not be sufficient to hold the front wheel in position if the quick release lever is opened while the bicycle is in use.

Read summary →
Inflatable toys and flotation aids

Ben 10 "Baby Float" aquatic toy

The product does not comply with the labeling requirements of Consumer Protection Notice No. 2 of 2009 - Consumer Product Safety Standard: Flotation Toys and Aquatic Toys, because it is not marked with the required warnings.

Read summary →
Sunglasses and fashion spectacles

Assorted sunglasses

The sunglasses do not contain the appropriate markings and labelling identifying the lens or category rating.

Read summary →
Bath toys

Face paints

The face paints do not have the mandatory ingredient label, as required by the Trade Practices (Consumer Product Information Standards) (Cosmetics) Regulations 1991.

Read summary →
Bath toys

Smash Waterball Mouse

The Smash Waterball Mouse has a cord capable of extending over 500mm. These types of products are banned under Consumer Protection Notice 20 of 2011 Permanent ban on yo-yo water balls.

Read summary →
Quadbikes and all-terrain vehicles (ATVs)

Suzuki LT-A750 XP

The stator coil charge may be reduced due to insufficient insulation material around the wiring inside the stator that could become affected by engine heat, causing the battery to go flat.

Read summary →
Indoor furniture and furnishings

Boho Beanbag Cover

The internal bag is not fitted with a child-resistant slide fastener and may allow access to the polystyrene beans.

Read summary →
Car parts and accessories

Essentials & Premium Recovery Kits

Product labelling on the outer packaging is not compliant with the relevant mandatory safety standard. Inner labels and instructions for use are compliant with the requirements of the mandatory standard.

Read summary →