Navy Metal Chair (Tolix Replica)
The tapering of the inside bottom of the chair legs may lead to an entrapment or laceration hazard.
15 product recalls were published during this week. Review the summaries below, then follow the official source before taking action.
The tapering of the inside bottom of the chair legs may lead to an entrapment or laceration hazard.
The affected models may have been manufactured with an improperly routed fuel tank vent line. The vent line may not have sufficient clearance to the exhaust head pipe and can cause the vent line to become kinked. A kinked vent line may results in a build up of pressure in the fuel tank.
In the event of an engine misfire, on a Model year 2015-2016 RZR XP 1000 / XP 4 1000 units, unburned fuel can be routed into the exhaust system. This can lead to excessive exhaust heat.
Affected models have been manufactured with a regulator that does not meet Polaris quality standards.
Affected models have been manufactured with heat shields that do not meet Polaris quality standards.
Some affected models have been manufactured with a fuse box seal that does not meet the Polaris quality standards.
The affected models may have been manufactured with an improperly routed fuel tank vent line. The vent line may not have sufficient clearance to the exhaust head pipe and can cause the vent line to become kinked. A kinked vent line may results in a build up of pressure in the fuel tank.
The 240V Power point is too close to the ensuite sink and does not comply with the standard.
Damage to the on/off switch through dropping or knocking could cause the switch to become live with 240V AC.
In some cases there may be a malfunction of the electronics. If the malfunction occurs, the engine may operate at a faster speed and/or the blades may continue to move for a short time after the trigger is released. Under certain circumstances, the machine may start to operate when only one trigger switch is pressed.
In some cases there may be a malfunction of the electronics. If the malfunction occurs, the engine may operate at a faster speed and/or the blades may continue to move for a short time after the trigger is released. Under certain circumstances, the machine may start to operate when only one trigger switch is pressed.
The tapering of the inside bottom of the chair legs may lead to an entrapment or laceration hazard.
The press studs may come loose and detach from the garment.
The wall charger is unapproved for the Australian market and does not have the correct pin configuration for Australian power outlets.
The press stud may detach from the garment during use.