Adria Altea 402PH Heat Shield
There may not be enough space between the stove heat shield and the gas supply hose underneath the stove.
17 archived Australian notices, each linked to its official Product Safety Australia source. The page updates automatically when new notices arrive.
There may not be enough space between the stove heat shield and the gas supply hose underneath the stove.
The Truma Combi Hotwater and gas pipe connecting to the hot water system may not be securely mounted. Vibration and movement of the gas pipe can cause it to leak gas within the caravan.
Liquefied Petroleum Gas (LPG) is a colourless, highly flammable gas that may leak and build up inside the caravan where the consumer gas piping is located inside the caravan. Some models may have defects in relation to the relevant gas safety standard for installation in caravans for non-propulsive purposes: LP Gas cylinder compartments are not correctly sealed or vented. Ventilation of the living area is not sized or located correctly. Gas safety labelling does not comply with the requirements for gas systems in recreational vehicles.
The drive wheel may separate from the awning motor. If this happens, the awning may open unintentionally or in an uncontrolled manner.
There is a risk of insufficient weld penetration on the arm of the axle, potentially resulting in a weak and insufficient weld strength.
In some variants of each of the affected models there is a socket outlet (power point or GPO) located too close to the sink, in breach of the Australian Standard AS/NZS3000:2007.
1. Main run of gas piping to the cooker (and the BBQ, if fitted) is located internally instead of outside the motorhome. 2. Some BBQs (where fitted) are permanently connected to the gas pipe when in the stowed position. 3. The LPG cylinder compartment vent hole may be undersized. 4. Instruction labelling missing or incomplete, for example a) Cylinder compartment label may be missing information b) Internal upper and lower vents may be missing a warning label that states that the vent must remain unrestricted during use of LPG c) The cooker may be missing a label stating that ventilation is required when the cooker is in use and that the cooker must not be used for space heating.
Some of the switches have been found to not work correctly (intermittently).
There is a risk of insufficient weld penetration and/or overgrinding of the weld on the suspension trailing arm elbow resulting in reduced material thickness.
The 240V Power point is too close to the ensuite sink and does not comply with the standard.
In certain situations, it is possible for the weld joining the front TV bracket post to the base plate to fail. This could allow the TV monitor to become detached from its stored position.
Due to incorrect wiring to the refrigerator during installation, the fridge gas burner may attempt to ignite by creating a spark at the time the tow vehicle ignition is turned off.
The 240V power outlet is incorrectly placed in the ensuite.
Wiring incorrectly secured to the rear of the oven may get excessively hot and melt the wiring insulation.
The gas bottle storage compartment may not be correctly sealed.
Six Jayco caravans will require a heavier duty jack to be supplied as the current jacks do not meet requirements. In addition, 126 vans require a new safety sticker be fitted to the jack.
The jack failed to comply with the mandatory standard due to the absence of warning labels and instructions.